Bellenar ultra volume is a dermal filler that is a sterile, translucent viscoelastic gel with a derivative of H.A. In every living thing, derivative of H.A has the same structure. It is a naturally occurring polysaccharide that is found in all bodily tissues, with the synovial fluid and the skin having particularly high quantities of it.Its results last for 12-18 Months.IndicationIt is designed to be utilized for the augmentation of facial tissue in order to treat depression in people over the age of 18 brought on by scars and volume loss from lipoatrophy.ContraindicationsWho have experienced allergic symptoms in the pastThe Site where another product was applied previouslyPatients with a history of H.A. hypersensitivityPatients with a history of filler raw material hypersensitivityPregnant or breastfeeding womenYoung individuals under the age of 18The ligaments, tendons, and bonesPrecautions:There is an inherent risk of infection It shouldn’t be applied to or close to anatomical sites where there is an active skin problem, inflammation, or similar ailmentWhen administering the medicine intravenously, patients should exercise caution since it might worsen bruising at the injection site if they are using non-steroidal anti-inflammatory medicationsBefore using it, it should be examined, and if it is abnormal, it should not be usedLatent or asymptomatic herpes virus infections may become active again as a result of injection proceduresInstructions for use:Only a doctor or other medical expert should handle the productNever combine it with other materials. Adhering to proper aseptic procedures is necessary while injecting it.Connect the needle to the syringe after removing the syringe’s tip cap. The recommended range for needle gauge is 21G to 30G, and a doctor’s discretion should be utilized to determine the best sterile needle to use. Before injecting, the injection site should be cleaned with alcohol or another appropriate solution.Consider the patient, their conditions, and their symptoms when determining the volume of the injection site. Inject gently and deliberately. Massage the injection site if necessary. To make it simpler to put the material, the injection needle may need to be shifted slightly, or it may be essential to switch out the injection needle if there is a lot of resistance or closing while pressing the plunger.The patient should be informed by the doctor whether extra periodic injections of the substance are necessary to maintain the treatment condition.Syringe, needle, and any unused components of an opened package need to be thrown away following the procedure.Side effects:On the surgical site, there may be inflammation, swelling, discomfort, soreness, mass, induration, short-term effect, erythema, local mobility, infection, and other symptoms. These side effects will go away on their own after one to two weeks.Inflammation symptoms (fever, redness, swelling, etc.) with a wound or pain may last for approximately a week after injection.After injecting, take care to check for any potential abscesses or hypersensitivity.Consult a specialist right away if the inflammatory symptom lasts more than a week or if any other unfavorable event occurs.Storage conditions:This product should be stored between 2 and 25 °C.Do not freeze itKeep away from sunlightA prefilled 1ml glass syringe is included in each carton. The product is for single use only.
